Tie a triangular band on the head

Tie a triangular band on the head

Bend the rule of this strip one and a half inches and place it on the head in such a way that the edge lies on the forehead near the eyebrows and with the tip hanging towards the back, wrap both ends of the strip around the scalp and wrap the ends around the scalp. Bring the ends together on the forehead and tie a knot. Now support the scalp with one hand and with the other hand pull the tip of the strip downwards and invert it upwards and fasten the end of the strip with a pin.

The bandage will become strong and will not slip.

If you intend to use this bandage on any part of the eye or scalp, such as the forehead, cheeks, etc., or on one of the round parts of the body, such as the arms, thighs, etc., fold it in the above way and reduce it. Make a wide strip and wrap the strip around and tie its ends with a knot, but it will be necessary to keep the width of the strip as needed.

Tie a triangle on the shoulder:

Place the middle part of the triangle on the shoulder and its tip on the neck now with its base bent slightly inward, wrap the ends over the middle of the arm, and tie another triangle. Take the strip and tie the left side flower strip by passing the tip of the first strip over the knot of this flower strip, pull it tight and pin it together with the strip.

The triangular bandage on the hip:

Fold the triangular bandage to make a less wide bandage and wrap it around the body slightly above the hip bones so that the knot is on the injured side. Take the bandage under and turn it downwards in a knot. Depending on the size of the wound, bend the margin inward with the rule of the other bandage. Now wrap the ends around the thigh and tie the ends of the bandage at one point. Install it so that it does not slip.

Placing a triangular bandage on the hand:

When it is intended to keep the fingers raised, bend the margin slightly along the rule of the bandage and then place the wrist on the margin so that the fingers are towards the tip of the bandage. Now bring the tip to the wrist and the ends. Wrap and tie around the wrist then bring the tip to the knot and fasten it with a pin on the armband and support the arm with a girl band.

Tie a triangular bandage on the foot:

Place the foot in the middle of the bandage so that the toes are towards the tip of the bandage. Now pull the strap tip forward, bring it to the back of the foot, and pin it.

Applying a triangular bandage on the chest:

Place the middle of the triangular bandage on the wound so that the tip of the bandage is on the shoulder on the side of the wound. Tie it in such a way that one end is longer than the other end. Now bring this length to the top and tie it there with the tip of the strip.

Tying a triangular belt on the back:

These belts are also tied in the same way as on the chest, the only difference is that the beginning of this belt is done on the back instead of the chest.

The triangular bandage on the elbow:

Before tying the triangular bandage on the elbow, bend the elbow to a right angle.

Bend a small fold inward on the base of the bandage.

On the back of the wrist, first, pass the ends of this strip over each other in front of the elbow and take it around the arm and bring it out one over the other and then tie them together and tie it by bringing the tip down.

Fractures and Dislocations:

Fractures are bones, and dislocations are usually caused by external violence. There are generally two types of bone fractures. First, the bones are broken in such a way that there is no visible wound, that is, the skin is not broken. It is said that another type of fracture that is usually found is that the bone is not broken into two pieces, but it is said that the bone is twisted and its nature cannot be known without taking an X-ray image and such. relatively high,